欢迎来到麦多课文档分享! | 帮助中心 海量文档,免费浏览,给你所需,享你所想!
麦多课文档分享
全部分类
  • 标准规范>
  • 教学课件>
  • 考试资料>
  • 办公文档>
  • 学术论文>
  • 行业资料>
  • 易语言源码>
  • ImageVerifierCode 换一换
    首页 麦多课文档分享 > 资源分类 > PDF文档下载
    分享到微信 分享到微博 分享到QQ空间

    DLA MS25467 REV E-2003 RELAYS ELECTROMAGNETIC 5 AMPERES 4 PDT TYPE I MAGNETIC LATCH SOLDER TERMINAL STUD MOUNTED HERMETICALLY SEALED《I型4 PDT 5安培焊接终端栓钉安装磁力锁密封电磁继电器》.pdf

    • 资源ID:696576       资源大小:56.64KB        全文页数:5页
    • 资源格式: PDF        下载积分:10000积分
    快捷下载 游客一键下载
    账号登录下载
    微信登录下载
    二维码
    微信扫一扫登录
    下载资源需要10000积分(如需开发票,请勿充值!)
    邮箱/手机:
    温馨提示:
    如需开发票,请勿充值!快捷下载时,用户名和密码都是您填写的邮箱或者手机号,方便查询和重复下载(系统自动生成)。
    如需开发票,请勿充值!如填写123,账号就是123,密码也是123。
    支付方式: 支付宝扫码支付    微信扫码支付   
    验证码:   换一换

    加入VIP,交流精品资源
     
    账号:
    密码:
    验证码:   换一换
      忘记密码?
        
    友情提示
    2、PDF文件下载后,可能会被浏览器默认打开,此种情况可以点击浏览器菜单,保存网页到桌面,就可以正常下载了。
    3、本站不支持迅雷下载,请使用电脑自带的IE浏览器,或者360浏览器、谷歌浏览器下载即可。
    4、本站资源下载后的文档和图纸-无水印,预览文档经过压缩,下载后原文更清晰。
    5、试题试卷类文档,如果标题没有明确说明有答案则都视为没有答案,请知晓。

    DLA MS25467 REV E-2003 RELAYS ELECTROMAGNETIC 5 AMPERES 4 PDT TYPE I MAGNETIC LATCH SOLDER TERMINAL STUD MOUNTED HERMETICALLY SEALED《I型4 PDT 5安培焊接终端栓钉安装磁力锁密封电磁继电器》.pdf

    1、 AMSC N/A 1 of 5 FSC 5945 INCH-POUND MS25467E 27 November 2003 SUPERSEDING MS25467D 5 Jun 1987 DETAIL SPECIFICATION SHEET RELAYS, ELECTROMAGNETIC, 5 AMPERES, 4 PDT TYPE I, MAGNETIC LATCH, SOLDER TERMINAL, STUD MOUNTED, HERMETICALLY SEALED INACTIVE FOR NEW DESIGN. NO LONGER USED EXCEPT FOR REPLACEMEN

    2、T PURPOSES. This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the relay described herein shall consist of this specification and the latest issue of MIL-PRF-6106. FIGURE 1. Dimensions and configurations. Provided by IH

    3、SNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS25467E 2 NOTES: 1/ Dimensions are in inches. 2/ Metric equivalents are given for general information only. 3/ Unless otherwise specified, tolerance is .010 (0.25 mm). 4/ Terminal numbers need not appear on relay he

    4、aders provided there is affixed to the relay a suitable legible circuit diagram that permanently and positively identifies each terminal location specified hereon. 5/ The use of diodes on ac relays is optional. Actual application must be shown on label. 6/ Shock, vibration, and acceleration requirem

    5、ents application with coils de-energized 7/ Relay is magnetically latched in both positions. 8/ Caution note to observe polarity must appear on relays with dc coils. 9/ In the event of conflict between the text of this specification and the references cited herein, the text of this standard shall ta

    6、ke precedence. 10/ Referenced Government documents of the issue listed in that issue of the Department of Defense Index of Specifications and Standards (DoDISS) specified in the solicitation form a part of this standard to the extent specified herein. TABLE I. Dash numbers and characteristics. Dash

    7、number MS25467- Type Coil Terminal type Mounting or mating socket Max weight in pounds D1 I dc Solder hook Stud 0.30 A1 I ac Solder hook Stud 0.32 FIGURE 1.Dimensions and configurations - Continued. Inches mm .000 0.00.001 0.03 .005 0.13.031 0.79 .040 1.02.062 1.57 .152 3.86.187 4.75 .375 9.53.687 1

    8、7.45 .750 19.051.032 26.21 1.187 30.15 1.531 38.89 1.812 46.02 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS25467E 3 TABLE II. Operating characteristics. Coil data Time - milliseconds max Rated Max Max pick-up voltage Contact Bounce Main Aux MS

    9、part no. MS25467- Coil Volts 1/ Freq Hz Res 10% Volts Amp Nor- mal 3/ High temptest Cont cur-rent test Drop out vol-tage Op-erate 4/ Rel-ease 5/ NO NC NO NC D1 X1, X2 Y1, Y2 28 dc N/A 29 0.17 18 18 19.8 N/A 25 N/A 2 2 N/A N/A A1 X1, X2 Y1, Y2 115 400 2/ N/A 122 0.07 90 90 95 N/A 25 N/A 2 2 N/A N/A 1

    10、/ CAUTION: Use of any coil voltage less than rated coil voltage will compromise the operation of the relay. 2/ MS25467-A1 may be used on 60 Hz if maximum ambient temperature is limited to +85C (maximum coil current shall be 0.077 ampere). 3/ Over the temperature range. 4/ With nominal coil voltage.

    11、5/ From nominal coil voltage. TABLE II. Rated contact load (amperes per pole) (case grounded). 28 V dc 115 V ac, 1 phase 115/200 V ac, 3 phase 1/ Main Aux Main Aux Main Aux Type of load Life operating cycles x 103NO NC NO NC 400 Hz 60 Hz 400 Hz 60 Hz 400 Hz 60 Hz 400 Hz 60 Hz See appropriate notes R

    12、esistive 100 5 5 5 4 Inductive 100 Inductive 20 3 3 3 2 Motor 100 1.5 1.5 1.5 1 Lamp 100 0.8 0.8 0.8 0.6 Transfer load 2/ Mechanical life reduced current 400 1.25 1.25 1.25 2 Mixed loads Applicable per specification 1/ Absence of value indicates relay is not rated for 3-phase application. 2/ Transfe

    13、r load indicates relay is suitable for transfer between unsynchronized ac power supplies at rating indicated Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS25467E 4 Environmental characteristics. Temperature range -70C to +125C Max altitude rating

    14、 80,000 ft Shock G-level 50 gs Duration 11 ms Max duration contact opening 10 s Vibration - sinusoidal G-level 10 gs Frequency range 5-1,500 Hz Acceleration 15 gs Electrical characteristics. Insulation resistance: Initial 100 megohms. After life or environmental tests 50 megohms. Dielectric strength

    15、 (sea level). Initial After life tests Coil to case 1,000 V rms 1,000 V rms Aux contacts All other points 1,000 V rms 1,000 V rms Dielectric strength (altitude). (When mounted in mating socket) 80,000 ft Coil to case 250 V rms Aux contacts All other points 250 V rms Max contact drop initial 0.150 vo

    16、lt. After life test 0.175 volt. Overload current 20 amperes. Rupture current 25 amperes. Duty rating Continuous. RFI specification MIL-STD-461. (Applicable to coil circuits of ac operated relays.) Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS254

    17、67E 5 Group A acceptance reports shall be submitted to the preparing activity on a yearly basis in order to retain qualification for this military specification sheet. Groups B and C inspections may be suspended at the discretion of the qualifying activity. Qualification by similarity: See MIL-PRF-6

    18、106. Custodians: Preparing activity:Navy - AS DLA - CC Air Force - 11 DLA - CC (Project 5945-1214-14) Review activities: Navy - EC NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using ASSIST Online database at www.dodssp.daps.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-


    注意事项

    本文(DLA MS25467 REV E-2003 RELAYS ELECTROMAGNETIC 5 AMPERES 4 PDT TYPE I MAGNETIC LATCH SOLDER TERMINAL STUD MOUNTED HERMETICALLY SEALED《I型4 PDT 5安培焊接终端栓钉安装磁力锁密封电磁继电器》.pdf)为本站会员(lawfemale396)主动上传,麦多课文档分享仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对上载内容本身不做任何修改或编辑。 若此文所含内容侵犯了您的版权或隐私,请立即通知麦多课文档分享(点击联系客服),我们立即给予删除!




    关于我们 - 网站声明 - 网站地图 - 资源地图 - 友情链接 - 网站客服 - 联系我们

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1 

    收起
    展开