欢迎来到麦多课文档分享! | 帮助中心 海量文档,免费浏览,给你所需,享你所想!
麦多课文档分享
全部分类
  • 标准规范>
  • 教学课件>
  • 考试资料>
  • 办公文档>
  • 学术论文>
  • 行业资料>
  • 易语言源码>
  • ImageVerifierCode 换一换
    首页 麦多课文档分享 > 资源分类 > PDF文档下载
    分享到微信 分享到微博 分享到QQ空间

    DLA MIL-PRF-8805 38 H-2012 SWITCHES PUSH MOMENTARY 4 CIRCUIT 4 AMPERES OR LOW LEVEL DUSTTIGHT.pdf

    • 资源ID:693122       资源大小:51.31KB        全文页数:4页
    • 资源格式: PDF        下载积分:10000积分
    快捷下载 游客一键下载
    账号登录下载
    微信登录下载
    二维码
    微信扫一扫登录
    下载资源需要10000积分(如需开发票,请勿充值!)
    邮箱/手机:
    温馨提示:
    如需开发票,请勿充值!快捷下载时,用户名和密码都是您填写的邮箱或者手机号,方便查询和重复下载(系统自动生成)。
    如需开发票,请勿充值!如填写123,账号就是123,密码也是123。
    支付方式: 支付宝扫码支付    微信扫码支付   
    验证码:   换一换

    加入VIP,交流精品资源
     
    账号:
    密码:
    验证码:   换一换
      忘记密码?
        
    友情提示
    2、PDF文件下载后,可能会被浏览器默认打开,此种情况可以点击浏览器菜单,保存网页到桌面,就可以正常下载了。
    3、本站不支持迅雷下载,请使用电脑自带的IE浏览器,或者360浏览器、谷歌浏览器下载即可。
    4、本站资源下载后的文档和图纸-无水印,预览文档经过压缩,下载后原文更清晰。
    5、试题试卷类文档,如果标题没有明确说明有答案则都视为没有答案,请知晓。

    DLA MIL-PRF-8805 38 H-2012 SWITCHES PUSH MOMENTARY 4 CIRCUIT 4 AMPERES OR LOW LEVEL DUSTTIGHT.pdf

    1、AMSC N/A FSC 5930 INCH-POUND MIL-PRF-8805/38H 6 December 2012 SUPERSEDING MIL-PRF-8805/38G 4 October 2004 PERFORMANCE SPECIFICATION SHEET SWITCHES, PUSH, MOMENTARY, 4 CIRCUIT, 4 AMPERES OR LOW LEVEL, DUSTTIGHT This specification is approved for use by all Departments and Agencies of the Department o

    2、f Defense. The complete requirements for acquiring the switches described herein shall consist of this specification and the latest issue of MIL-PRF-8805. Inches mm Inches mm Inches mm Inches mm Inches mm .010 0.25 .055 1.40 .25 6.4 .50 12.7 .75 19.1 .020 0.51 .06 1.5 .31 7.8 .640 16.26 .87 22.1 .02

    3、2 0.56 .109 2.77 .37 9.4 .65 16.5 .875 22.23 .03 0.8 .15 3.8 .375 9.53 .68 17.2 1.68 42.7 NOTES: 1. Dimensions are in inches. 2. Unless otherwise stated, tolerances are .02 (0.51 mm) for two place decimals and .005 (0.13 mm) for three place decimals. 3. The circuit and terminal arrangement shall be

    4、permanently and legibly marked on the switch case. 4. Metric equivalents are given for general information only. 5. Mounting hardware has .625-24 UNEF02A external thread and is removable for installation. 6. Alternative base metals and protective finishes, as approved by the qualifying activity, may

    5、 be utilized for hardware material FIGURE 1. Dimensions and configurations. TYPE C MOUNTING LOCKWASHER NASM35333-138 or equivalent TYPE F MOUNTINGTYPE G MOUNTING Hex Nut MS25082-B11 or equivalent Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PR

    6、F-8805/38H 2 REQUIREMENTS: Dimensions and configurations: See figure 1. Enclosure design: 2 (dusttight). Temperature characteristic: 1 (-55C to +85C). Shock type: (50 gs sine wave) method 213, test condition A, MIL-STD-202. Sinusoidal vibration grade: 1 (10 to 500 Hz). Weight: 0.40 pound maximum. Op

    7、erating characteristics: Total plunger travel: .085 .015 inch. Operating force: 4 1 pounds. Strength of actuator means: 25 pounds. Terminal strength: 5 pounds. Finish: Shall be corrosion resistant, black and lusterless. Dielectric withstanding voltage: Sea level: 1,000 V rms; 1,000 V rms between all

    8、 terminals and mounting plate and 200 V rms between all terminals following electrical endurance. Mechanical endurance: 50,000 cycles. Electrical endurance: 25,000 cycles. Electrical ratings: See table I. Sand and dust: Applicable. Low level circuit: Applicable when specified (see table III). Electr

    9、onic logic circuit (5.o V dc, .010 ampere): Applicable when specified (see table III); 25,000 cycles at an actuation rate of 120 cycles per minute maximum with no “stick“, or “misses“, allowed when tested in accordance with ANSI/ECA RS448, method 17 as follows: Test condition: Each switch contact sh

    10、all be tested using a 5.0 0.5 V dc, 10 1 mA resistive load. During each closure of the contacts, the voltage drop across the switch terminals shall be monitored for a duration of no less than 50 percent of each contact static closure. The switch contacts need not be monitored until 10 milliseconds a

    11、fter the initial contact closure to exclude any contact bounce. During each opening of the contacts, the voltage drop across the switch terminals shall be monitored for a duration of no less than 50 percent of each contact opening. A voltage of 2.1 volts or greater across the switch terminals shall

    12、constitute a contact “miss“ (failure to properly close the circuit). A voltage drop of less than 90 percent of the open-circuit voltage shall constitute a contact “stick“ (failure to properly open the circuit). The monitoring device shall either record the number of contact closures at which “sticks

    13、“ and/or “misses“ occur, or discontinue the test when “sticks“ and/or “misses“ occur. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-8805/38H 3 Operating temperature: a. 25 percent for the test cycle at -55C specified. b. 25 percent for the

    14、test cycle at room ambient conditions. c. 50 percent for the test cycle at +85C. Qualification: Group submission: See table II. Part number: See table III. TABLE I. Electrical ratings, power circuit switches (MS27903-1 through MS27903-6). Load Sea level 28 V dc 115 V ac, 400 Hz (Amperes) (Amperes) R

    15、esistive 4 4 Inductive 2 2 Motor 2 2 NOTE: MS27903 was superseded by MIL-PRF-8805/38; the MS27903 Part Numbers (PINS) were retained. TABLE II. Qualification inspection. Examination or test Basic switch Other switch samples Extent of Approval Qualification inspection table of MIL-PRF-8805 MS27903-1 o

    16、r MS27903-2 (all sample units) MS27903-3, MS27903-4, MS27903-5, MS27903-6 (2 sample units each) Visual and mechanical examination MS27903-1 through MS27903-06 Group I and group X of the qualification inspection table of MIL-PRF-8805 plus 2 additional samples shall be subjected to logic level circuit

    17、 and operating characteristics MS27903-7 or MS27903-8 All Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-8805/38H 4 TABLE III. Part numbers and characteristics. Part number Type Button Electrical ratings MS27903-1 C Black Power circuit ratin

    18、g (see table I) MS27903-2 C Red MS27903-3 G Black MS27903-4 G Red MS27903-5 F Black MS27903-6 F Red MS27903-7 C Black Low level and logic level rating MS27903-8 C Red MS27903-9 G Black MS27903-10 G Red MS27903-11 F Black MS27903-12 F Red NOTE: MS27903 was superseded by MIL-PRF-8805/38; the MS27903 P

    19、art Numbers (PINS) were retained. Referenced Documents: MIL-PRF-8805 MS25082 MIL-STD-202 ECA-RS448 NASM 35333 Custodians: Preparing activity: Navy - EC DLA - CC Air Force - 85 DLA - CC (Project 5930-2011-117) Review activities: Air Force 99 NOTE: The activities listed above were interested in this d

    20、ocument as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.dla.mil/ . Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-


    注意事项

    本文(DLA MIL-PRF-8805 38 H-2012 SWITCHES PUSH MOMENTARY 4 CIRCUIT 4 AMPERES OR LOW LEVEL DUSTTIGHT.pdf)为本站会员(diecharacter305)主动上传,麦多课文档分享仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对上载内容本身不做任何修改或编辑。 若此文所含内容侵犯了您的版权或隐私,请立即通知麦多课文档分享(点击联系客服),我们立即给予删除!




    关于我们 - 网站声明 - 网站地图 - 资源地图 - 友情链接 - 网站客服 - 联系我们

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1 

    收起
    展开