1、 REVISIONS LTR DESCRIPTION DATE APPROVED A Update drawing to new format 08 July 2005 R. L. Taylor Prepared in accordance with ASME-Y14.100 Selected item drawing REV PAGE REV A A A REV STATUS OF PAGES PAGE 1 2 3 PREPARED BY PMIC N/A Richard Wilson DEFENSE ELECTRONICS SUPPLY CENTER, DAYTON, OHIO 45444
2、-5000 CHECKED BYa TITLE Clarence Bizius APPROVED BY Ivan R. Jones METER, ELECTRICAL INDICATING, MR26A200SPAER SIZE CAGE CODE 14933 DWG. NO. 84189 Original date of drawing 02 January 1985 A REV PAGE 1 OF 3 THIS DRAWING WAS REVIEWED ON 08 July 2005 AND IS VALID FOR ACQUISITION. CURRENT DESIGN ACTIVITY
3、 CAGE CODE 037Z3 DEFENSE LOGISTICS AGENCY DEFENSE SUPPLY CENTER COLUMBUS COLUMBUS, OHIO 43218-3990 AMSC N/A 6625-E072 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. REQUIREMENTS: 1. Meter shall meet shock, vibration and temper
4、ature requirements of MIL-PRF-10304/5. 2. Housing material aluminum flange, steel case. 3. Scale length 1.57 inches. 4. Accuracy 2 percent of full scale. 5. Terminals 0.250-28 UNEF threaded studs with two nuts, two flat washers, two lockwashers (toothed) and a solder lug on each terminal. 6. Mountin
5、g hardware 4-40 screws and nuts. 7. Meter movement 200 microampere dc. 8. Meter to be RFI shielded. 9. DC resistance 1100 ohms. 10. Configuration shall be as shown on figure 1. Front glass may be full circle. 11. Scale face shale be as shown on figure 2. Scale numbers may appear above or below scale
6、 arc on scale face. 12. Scale calibration shall be in accordance with table I. 13. Polarity the left terminal (as viewed from the rear with the meter in the normal mounting position) shall be the positive terminal. 14. Terminal identification the symbol “+” shall be marked on the positive terminal o
7、r on the case as close to the positive terminal as possible. 14933 84189 DEFENSE ELECTRONICS SUPPLY CENTER, DAYTON, OHIO 45444-5000 A REVPAGE2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. TABLE I Current uA Scale Reading 0 100 200 - 3 0 + 3 14933 84189 DEFENSE ELECTRONICS SUPPLY CENTER, DAYTON, OHIO 45444-5000 A REVPAGE3 Inch mm .125 3.175 2.69 68.326 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
