1、 NOTICE OF REVISION (NOR) This revision described below has been authorized for the document listed. 1. DATE (YYMMDD) 03-01-17 Form Approved OMB No. 0704-0188 Public reporting burden for this collection is estimated to average 2 hours per response, including the time for reviewing instructions, sear
2、ching existing data sources, gathering and maintaining the data needed, and completing and reviewing the collection of information. Send comments regarding this burden estimate or any other aspect of this collection of information, including suggestions for reducing this burden, to Department of Def
3、ense, Washington Headquarters Services, Directorate for Information Operations and Reports, 1215 Jefferson Davis Highway, Suite 1204, Arlington, VA 22202-4302, and to the Office of Management and Budget, Paperwork Reduction Project (0704-0188), Washington, DC 20503. PLEASE DO NOT RETURN YOUR COMPLET
4、ED FORM TO EITHER OF THESE ADDRESSED. RETURN COMPLETED FORM TO THE GOVERNMENT ISSUING CONTRACTING OFFICER FOR THE CONTRACT/ PROCURING ACTIVITY NUMBER LISTED IN ITEM 2 OF THIS FORM.2. PROCURING ACTIVITY NO. 3. DODAAC 4. ORIGINATOR b. ADDRESS (Street, City, State, Zip Code)Defense Supply Center Columb
5、us 3990 East Broad Street Columbus, Ohio 43216-5000 5. CAGE CODE037Z3 6. NOR NO.5935-R001-03 a. TYPED NAME (First, Middle Initial, Last) Ron Gary 7. CAGE CODE037Z3 8. DOCUMENT NO.84149 9. TITLE OF DOCUMENT Connector, Plug, Electrical, Coaxial, Radio Frequency, Series SMA for Semirigid Cables 10. REV
6、ISION LETTER 11. ECP NO.N/A a. CURRENTN b. NEWP 12. CONFIGURATION ITEM (OR SYSTEM) TO WHICH ECP APPLIESALL 13. DESCRIPTION OF REVISIONSheet 1: Revisions Ltr. Column; add “P” Revisions description column; add “Changes in accordance with NOR 5935-R001-03”. Revisions date column; add “03-01-17” Revisio
7、ns rev status of pages, blocks 1 and 5, add “P”. Revisions rev status of sheet 1, add “P”. Sheet 5: Revisions rev status of sheet , add “P”. Sheet 5: Add the following new Vendor PIN “ DSCC drawing PIN 1/ Vendor CAGE Vendor reference PIN Number 84149SSG 00779 1050605-1 or 1050629-1 84149SSGA-1 00779
8、 1050631-1 “ 14. THIS SECTION FOR GOVERNMENT USE ONLY a. (X one) X (1) Existing document supplemented by the NOR may be used in manufacture. (2) Revised document must be received before manufacturer may incorporate this change. (3) Custodian of master document shall make above revision and furnish r
9、evised document. b. ACTIVITY AUTHORIZED TO APPROVE CHANGE FOR GOVERNMENTDSCC-VAI c. TYPED NAME (First, Middle Initial, Last)ROBERT HEBER d. TITLECHIEF, INTERCONNECTION DEVICES e. SIGNATURERobert M. Heber f. DATE SIGNED (YYMMDD) 03-01-17 15a. ACTIVITY ACCOMPLISHING REVISIONDSCC-VAI b. REVISION COMPLE
10、TED (Signature)Ron Gary c. DATE SIGNED (YYMMDD)03-01-17 DD Form 1695, APR 92 Previous editions are obsolete Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-REVISIONS LTR DESCRIPTION DATE APPROVED J Add vendor PINs for CAGE 94375: Changes in accordanc
11、e with NOR 5935-R003-93. 13 January 1993 Randy Larson K Delete vendor CAGE 94375 and PINs added by NOR 5935-R003-93. Add vendor PINs for CAGE 34078: Changes in accordance with NOR 5935-R008-93. 14 April 1993 Randy Larson L Add vendor PINs for CAGE 24931: Add vendor PINs for CAGE 95077: Add name and
12、address for CAGE 24931 and 95077. (Changes in accordance with NOR 5935-R016-93). 17 July 1993 Randy Larson M Change dimension “B” in table I to .335 max. Editorial changes throughout. 18 May 1994 Randy Larson N Part or Identifying Number (PIN) and source update. 16 November 2001 Robert M. Heber THE
13、ORIGINAL FIRST PAGE OF THIS DRAWING HAS BEEN REPLACED. Prepared in accordance with MIL-STD-100 REV PAGE REV N N N N N N REV STATUS OF PAGES PAGE 1 2 3 4 5 6 PREPARED BY PMIC N/A Ron Gary DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OHIO 43216-5000 CHECKED BY TITLE C. W. Koeller APPROVED BY R. Larson CO
14、NNECTOR, PLUG, ELECTRICAL, COAXIAL, RADIO FREQUENCY, SERIES SMA FOR SEMIRIGID CABLES SIZE CAGE CODE 037Z3 DWG. NO. 84149 Original date of drawing 5 November 1984 A REV N PAGE 1 OF 6 AMSC N/A 5935-E620 DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.Provided by IHSNot
15、 for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. 037Z3 84149 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 A REV N PAGE 2 NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for information only. 3. Metric equivalents ar
16、e in parentheses. 4. Coupling nuts shall be passivated. 5. Wrench flats to accommodate standard wrench opening in accordance with FED-STD-H28, appendix 10. 6. All undimensioned pictorial configurations are for reference purposes only. 7. See “Interface, series SMA, pin contact” figure of MIL-STD-348
17、. 8. No special tools shall be required for assembly to cables. 9. Dimensions A, B, and C, see Part or Identifying Numbers (PINs) in table I. 10. Steel bodied connectors shall be gold plated at least in the area of solder attachment in accordance with MIL-PRF-39012. 11. Gaskets shall be Viton A or e
18、quivalent (Viton A is a brand name of E. I Dupont de Nemours Company (84149 SSG-1 and 84149SSGA-1 only). FIGURE 1. General configuration.Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. 037Z3 84149 DEFENSE SUPPLY CENTER, COLUMBU
19、S COLUMBUS, OH 43216-5000 A REV N PAGE 3 ENGINEERING DATA: Nominal impedance: 50 ohms. Frequency range: 0 to 18 GHz. Voltage rating (at sea level): M17/130-RG402: 500 V rms. M17/133-RG405: 335 V rms. Operating temperature: -65C to +165C. REQUIREMENTS (requirements of drawing 84148 are applicable): D
20、imensions and configuration: See figure 1 and MIL-STD-348. Force to engage and disengage: Longitudinal force: Not applicable. Torque: 2 inch-pounds, maximum. Coupling proof torque: 15 inch-pounds, minimum. Hermetic seal: Not applicable. Leakage (pressurized connectors): Not applicable. Center contac
21、t retention: 6 pounds minimum axial force. Radial torque: Not applicable. Voltage standing wave ratio (VSWR). Captive Noncaptive 84149SSG, 84149SSGA 84149SSG-1, 84149SSGA-1 1.06 + .007F (F IN GHz) (M17/130-RG402) 1.05 + 0.005F (M17/130-RG402) 1.07 + .01F (F IN GHz) (M17/133-RG405) 1.07 + 0.005F (M17
22、/133-RG405) Moisture resistance: MIL-STD-202, method 106, except step 7b shall be omitted. Resistance shall be 200 megohms within 5 minutes after removal from humidity. Contact resistance (milliohms, maximum): Initial After environment Center contact: 3.0 4.0 Outer contact: 2.0 Not applicable Cable
23、outer conductor to body 0.5 Not applicable Dielectric withstanding voltage at sea level: 1,000 V rms, minimum. Vibration, high frequency. MIL-STD-202, method 204, test condition D. Corona level: Altitude: 70,000 feet minimum. M17/130-RG402: 375 volts, minimum. M17/133-RG405 250 volts, minimum. Provi
24、ded by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. 037Z3 84149 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 A REV N PAGE 4 Shock (specified pulse): MIL-STD-202 method 213, test condition I. Thermal shock: MIL-STD-202, method
25、 107, test condition B (except high temperature shall be +115C). Barometric pressure (reduced): MIL-STD-202, method 105, test condition C. RF high potential withstanding voltage: M17/130-RG402: 1,000 volts, minimum. M17/133-RG405: 670 volts, minimum. Frequency: 5 MHz, minimum. Leakage current: Not a
26、pplicable. Cable retention force: M17/130-RG402: 60 pounds, minimum. M17/133-RG405: 30 pounds, minimum. Torque: M17/130-RG402: 55 inch-ounces. M17/133-RG405: 16 inch-ounces. Coupling mechanism retention force: 60 pounds, minimum. RF leakage: -90 dB minimum tested at a frequency between 2 and 3 GHz.
27、RF insertion loss: dB max - .03 x frequency in (GHz). Test frequency at 6.0 GHz. Note: These parts are for use in general radio frequency applications. Part or Identifying Number (PIN): See table I. TABLE I. Connector-to-cable reference. Dimensions (inches) PIN 1/ Cable accommodation A B C 84149SSG
28、2/ N/A N/A .440 .020 84149SSG-1 3/ M17/130-RG402 .205 to .218 .335 max N/A 84149SSGA 2/ N/A N/A 440 .020 84149SSGA-1 3/ M17/133-RG405 .214 to .220 .335 max N/A 1/ These connectors accommodate all cables referenced in associated specification sheets (MIL-C-17/130, MIL-C-17/133). 2/ These connectors h
29、ave captivated center contacts. 3/ Gaskets shall be made of either vitron A or neoprene. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. 037Z3 84149 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 A REV N PAGE 5 Superse
30、ssion data: See table II. TABLE II. Superssion table. Preferred PIN Superseded PIN 84149SSG 84148/84149SSG 84149SSGA 84148/84149SSGA Approved sources of supply are listed herein. Additional sources will be added as they become available. The vendors listed on the requirements drawing have agreed to
31、this drawing and a certificate of compliance has been submitted to DSCC-VAI. DSCC drawing PIN 1/ Vendor CAGE Number Vendor reference PIN 84149SSG 00795 24931 30990 34078 95077 1301031G003-006 39P180-1 5285-135-1CCSF SMA4141-79-002-02 SF2902-6123 84149SSGA 00779 00795 24931 30990 34078 95077 413071-1
32、 1301094G003-001 39P180-2 5285-135-2CCSF SMA4085-79-005-02 SF2906-6105 84149SSG-1 24931 30990 34078 95077 39P180-3 5285-135-3SF SMA-0141-79-010-02 SF2902-6124 84149SSGA-1 24931 30990 34078 95077 39P180-4 5285-135-4SF SMA-0285-79-002-02 SF2906-6106 1/ Parts must be purchased to this DSCC PIN to assur
33、e that all performance requirements and tests are met. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. 037Z3 84149 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 A REV N PAGE 6 Vendor CAGE Vendor name number and addres
34、s 00779 AMP Incorporated Green Valley Road Seven Valley, PA 17360 00795 Delta Electronics 416 Cabot Street Beverly, MA 01915 24931 Specialty Connector Co. 2100 Earlywood Dr. Franklin, IN 46131 30990 Connecting Devices, Incorporated 2400 Grand Avenue Long Beach, CA 90815 34078 Midwest Microwave 6564 S. State Road Saline, MI 48176 95077 Soliton/Vector Microwave Products 3301 Electronics Way West Palm Beach, FL 33407 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
