1、EUROPEAN RADIOCOMMUNICATIONS COMMITTEE ERC Decision of 1st December 1995 on the adoption of national type approval regulations for equipment to be used in the land mobile service using angle modulation based on the European Telecommunications Standard (ETS) 300 086 (ERC/DECl(95)02) EUROPEAN CONFEREN
2、CE OF POSTAL AND TELECOMMUNICATIONS ADMINISTRATIONS STD-CEPT ERC/DEC/(95)02-ENGL 1995 I 232b4L4 OOL4430 T92 I Copyright 1995 the European Conference of Postal and Telecommunications Administrations (CEPT) STD-CEPT ERC/DEC/(95)02-ENGL 1995 W 232b414 0014431 929 ssl LSS I EXPLANATORY MEMORANDUM 1. INT
3、RODUCTION The free movement of radiacommunications goods and the provision of Europe-wide services for radiocommunications are only achievable if there exist common regulations throughout Europe regarding availability of frequency bands, type approval requirements and border crossing procedures. A b
4、asic requirement to fulfil these objectives is the Europe-wide implementation of national regulations based on the European Telecommunications Standards (ETSs) developed by the European Telecommunications Standards Institute (ETSI). This Decision (ERC/DEC/(95)02) provides the necessary mechanism for
5、 CEPT administrations to commit themselves to implement, within their national regimes, European Telecommunications Standard 300 086l and withdraw any conflicting national standard. 2. BACKGROUND Both the ERC and ETSI are involved in the development of common regulations, as described in (1) above.
6、The Memorandum of Understanding between ERC and ETSI explains the respective responsibilities of the two organisations and its annex describes the principles of cooperation. The ERC, for its part, should, inter alia, adopt Decisions on the introduction of ETSI standards into national type approval r
7、egimes. ETS 300 086 has been prepared by the Radio Equipment and Systems (RES) Technical Committee of ETSI. The standard has undergone the ETSI standards approval procedure and is now published as an ETS. The ETS, which is based on CEPT Recommendation T/R 24-01, is a general standard which may be su
8、perseded by specific standards covering specific applications. The use of the frequency range (30-1000 MHz) covered by ETS 300 086 is not harmonised within CEPT. Although CEPT Recommendation T/R 25-08 provides preferred arrangements for some frequency bands designated for mobile radio systems, Admin
9、istrations have adopted different arrangements, to meet national requirements, for frequency bands, duplex separations and channel separations (12.5, 20 and 25 kHz). Further, the equipment used in this frequency range is subject to national licensing and frequency planning which requires specificati
10、on of, inter alia, frequency of operation and effective radiated power (e.r.p.) and, in some cases, additional requirements to improve spectrum utilisation, for example timers to limit maximum duration of transmissions. Such parameters of requirements are considered as outside the scope of this Deci
11、sion. Nevertheless, there are a number of parameters, in particular those considered by the ERC as essential for spectrum management purposes, which can be harmonised by adopting within national type approval regulations the limit values and measurement methods provided in ETS 300 086. 3. REQUIREMEN
12、TS FOR AN ERC DECISION The allocation and assignment of radio frequencies and the complementary equipment type approval regimes in CEPT member countries are laid down by law, regulation or administrative action. The ERC recognises that for harmonised fixed and mobile radio services to be introduced
13、successfully throughout Europe, manufacturers and operators must be given the confidence to make the necessary investment in the development and procurement of new systems. Commitment by CEFT administrations to implement this ERC Decision will provide a clear indication that equipment conforming to
14、national type approval regulations based on ETS 300 086 will have the benefit of a Europe-wide market. ETS 300 086: “Technical characteristics and test conditions for radio equipment with an internal or external RF connector intended primarly for analogue speech.“ ERC Decision of 1st December 1995 o
15、n the adoption of national type approval regulations for equipment to be used in the land mobile service using angle modulation based on the European Telecommunications Standard (ETS) 300 086 The European Conference of Postal and Telecommunications Administrations, considering: that CEPT has a long
16、term objective to harmonise the use of frequencies and the related regulatory regimes, that such harmonisation will benefit administrations, manufacturers, operators and users, that ETSI has published ETS 300 086 for equipment to be used in the land mobile service operating on radio frequencies betw
17、een 30 MHZ and 1000 MHz with channel separations of 12.5 kHz, 20 kHz and 25 kHz and intended primarily for analogue speech, that, for the foreseeable future, many official, public and private networks will continue to use land mobile equipment having the technical characteristics described in c) abo
18、ve, that, in accordance with the Memorandum of Understanding between ERC and ETSI, the ERC shall adopt ERC Decisions on the introduction of ETSI standards into national type approval regimes, that the use of radio equipment is subject to national licensing and frequency planning requirements, in par
19、ticular for frequency of operation, limit of maximum duration of transmission (e.g. use of time-oudtimers) and e.r.p., that suitable transitional arrangements are given in CEPT Recommendation T/R 01-05, DECIDES 1. to adopt, by 1 April 1996, national type approval regulations for equipment to be used
20、 in the land mobile service using angle modulation, based on the limit values and measurement methods for spectrum management parameters2 contained in ETS 300 086, with the exception of those parameters which are subject to national licensing requirements, 2. to withdraw any conflicting national reg
21、ulation(s), 3. that CEPT Member administrations shall communicate the national measures implementing this Decision to the ERC Chairman and the ER0 when the Decision is nationally implemented. Annex 1 contains parameters from ETS 300 086 to be included in national type approval regulations. Annex 2 i
22、s provided for information to show which options have been adopted by each Administration in those cases where ETS 300 086 offers a choice. m o .“ Y 4 Ld s k B O Y Fi rc O c) 4 ir) N N a 8 3 v! m M E o Ld .- 3 8 s e 4 e, o Li v) E O 3a O v! 4 d b 3 O a 3 E 8 o 8 Y a- 4 Y - x P B B .“ a .“ g Y a o E
23、M E .e 2 R 8 .9 8 .$ LI);? 12 Q 5 STD-CEPT ERC/DEC/(95)02-ENGL 1995 2326434 O034434 638 M 2 ,h .3 . Y .3 v) f4 3 !3 E 3 E 9 o a 0 P V .3 Y .3 Y .3 v) 8 .3 5 a 8 2 ANNEX 2 (informative) Iceland v3, u3 Adoption of ETS 300 086: National variations for channel spacing and temperature range. 2 Finland Fr
24、ance Germany Greece Ireland Italy Latvia Liechtenstein Lithuania Luxembourg Malta Moldova Monaco v1, u1 Nevertheless channel spacing of 25 liHz may be used in UHF band on a transitional basis until 206 STDoCEPT ERC/DEC/(95)02-EMGL 1995 m 2326414 0014q3b 400 m Key: Channel spacing options: Temperatur
25、e range options U= UHF1 = 12.5 kHz v=vHF 2=20kHz 2 = -15 to +55“C 3 = -10 to +55“C 1 = -25 to +55“C 3=25kHz STD-CEPT ERC/DEC/(95)02-ENGL 3995 W 2326434 0034437 347 W iaar I European Radiocommunications Committee Decision CEPT ERCIDEC/(95)02 On the adoption of national type approval regulations for e
26、quipment to be used in the land mobile service using angle modulation based on the European Telecommunications Stanard (ETS) 300 086 As of 18 April 1996 the following CEE Members have committed themselves to apply the terms of this Decision: Austria Belgium Croatia Einland France Iceland Ireland Lie
27、chtenstein Netherlands Norway Portugal Sweden Switzerland United Kingdom After 18 April 1996 the undermentioned CEPT Members have committed themselves to apply the terms of this Decision: Cyprus Denmark Germany Hungary Italy Poland Turkey Spain State 26.02.1997 t32b434 0034061 T32 CEPTEWCDEC(.99)Q2
28、ERC Decision of 1 st December 1995 on the adoption of national type approval regulations for equipment to be used in the land mobile service using angle modulation based on the European Telecommunications Standard (ETS) 300 086 Imp1 YeS YeS YeS YeS YeS Planned Planned YeS YeS Y9S YeS YeS YeS YeS YeS
29、 Yes YeS Under study YeS YeS Yes Under study YeS YeS YeS YeS Remarks Radio Set and Terminal Equipment Ordinance. Published in Federal Law Gazette No. 71 2/1994, latest revision in Federal Law Gazette No. 31511 996 dated 5 July Channel spacing: V1, U1 (V3, U3 phasing out): Temperature range: 3 By imp
30、lementing ETS 300 086 in national regulations as TB 92 026 Rev A THK 16B/96M. Channel spacing: 25 kHz mainly, 12.5 kHz limited use. Temperature range: -25Q to +55% (mobiles and portables) -1 O2 to +55% (base stations) Channel spacing: VHF 12.5 kHz/UHF 12.5 kHz Temperature range: Formerly option 3(-1
31、 o“ to +55%). The temperature range option has been removed by ETSI and the UK intends to adopt the harmonised range of -20Q to +55% in the future Intent of this Decision is met through the national footnotes H39. H41, H42. H47. H53, H59, H68, H71, H73, H75, H78. Adoption of options in Annex 2: Chan
32、nel spacing: V1, V2, V3, U1, U2, U3. Temperature range: 3 (wider temperature range is also permissible depending on the declaration of the manufacturer) Channel Spacing: 12.5 kHz. Temperature range: -1 Oe to +552C Channel spacing adopted for both ETS is 12.5 kHz for VHF and UHF bands. Nevertheless c
33、hannel spacing of 25 kHz may be used in UHF band on a transitional basis until 2006 Regulation issued by the Ministry of Communications. Channel spacing: VHF and UHF: 25 kHz. Temperature range: -15e to +SC Verordnung ber die technischen Anforderungen fr Teilnehmeranlagen Channel spacing: V1, V2 and
34、U1. Temperature range: -1 Oe to +55% Channel spacing: 25 kHz, also 12.5 kHz. Temperature range: 1 Verordnung ber die technischen Anforderungen fr Teilnehmeranlagen 2.9.1997. Regulation on technical requirements for radio stations, art. 11 (ff.Gaz. of SVN, No. 50/97) Annex 2: U1 and V1; U3 and V3 for already existing networks; free choise of one of the ambient temperature ranges
