1、 Reference number ISO/IEC 13560:2009(E) ISO/IEC 2009INTERNATIONAL STANDARD ISO/IEC 13560 First edition 2009-12-01Information technology Telecommunications and information exchange between systems Procedure for the registration of assigned numbers for ISO/IEC 26907 and ISO/IEC 26908 Technologies de l
2、information Procdure denregistrement des numros dordre pour lISO/CEI 26907 et lISO/CEI 26908 ISO/IEC 13560:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces
3、which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems
4、 Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely eve
5、nt that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHT PROTECTED DOCUMENT ISO/IEC 2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or
6、 mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web w
7、ww.iso.org Published in Switzerland ii ISO/IEC 2009 All rights reservedISO/IEC 13560:2009(E) ISO/IEC 2009 All rights reserved iiiContents Page Foreword iv Introduction.v 1 Scope1 2 Normative references1 3 Terms and definitions .1 4 International Registers2 4.1 PHY ID.2 4.2 Specifier ID.2 4.3 Regulat
8、ory Domain2 5 Registration Authority.2 5.1 Appointment 2 5.2 Duties2 5.2.1 Maintenance of International Registers 2 5.2.2 Publication of public content of International Registers 2 5.2.3 Inform the requestor of the decision.2 6 Registration requests3 7 Registration procedure.3 8 Withdrawal procedure
9、.3 9 Amendment procedure .3 10 Appeal procedure 3 ISO/IEC 13560:2009(E) iv ISO/IEC 2009 All rights reservedForeword ISO (the International Organization for Standardization) and IEC (the International Electrotechnical Commission) form the specialized system for worldwide standardization. National bod
10、ies that are members of ISO or IEC participate in the development of International Standards through technical committees established by the respective organization to deal with particular fields of technical activity. ISO and IEC technical committees collaborate in fields of mutual interest. Other
11、international organizations, governmental and non-governmental, in liaison with ISO and IEC, also take part in the work. In the field of information technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1. International Standards are drafted in accordance with the rules g
12、iven in the ISO/IEC Directives, Part 2. The main task of the joint technical committee is to prepare International Standards. Draft International Standards adopted by the joint technical committee are circulated to national bodies for voting. Publication as an International Standard requires approva
13、l by at least 75 % of the national bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO and IEC shall not be held responsible for identifying any or all such patent rights. ISO/IEC 13560 was prepared by Ecma
14、International (as ECMA-381) and was adopted, under a special “fast-track procedure”, by Joint Technical Committee ISO/IEC JTC 1, Information technology, in parallel with its approval by national bodies of ISO and IEC. ISO/IEC 13560:2009(E) ISO/IEC 2009 All rights reserved vIntroduction This Internat
15、ional Standard specifies the registration procedures for the PHY ID, Specifier ID and Regulatory Domain registers used in ISO/IEC 26907 and ISO/IEC 26908. Entries in these registers are likely to be added over time. Therefore, these contents are implemented as registers rather than as tables in the
16、base standards. INTERNATIONAL STANDARD ISO/IEC 13560:2009(E) ISO/IEC 2009 All rights reserved 1Information technology Telecommunications and information exchange between systems Procedure for the registration of assigned numbers for ISO/IEC 26907 and ISO/IEC 26908 1 Scope This International Standard
17、 specifies the procedure to be followed by a Registration Authority in preparing, maintaining and publishing International Registers of assigned numbers and associated descriptions for entries specified in Clause 4, for use with ISO/IEC 26907 and ISO/IEC 26908. This International Standard does not s
18、pecify any method of using any attribute or identifier registered according to this International Standard. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references,
19、the latest edition of the referenced document (including any amendments) applies. ISO/IEC 26907:2009, Information technology Telecommunications and information exchange between systems High-rate ultra-wideband PHY and MAC standard ISO/IEC 26908:2009, Information technology Telecommunications and inf
20、ormation exchange between systems MAC-PHY interface for ISO/IEC 26907 ISO/IEC JTC 1 Directives, 5 thEdition 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. 3.1 bit binary digit with value ZERO or ONE 3.2 string sequence of at least one and at mos
21、t 50 characters encoded in ISO/IEC 8859-1 3.3 octet sequence of eight bits ISO/IEC 13560:2009(E) 2 ISO/IEC 2009 All rights reserved4 International Registers 4.1 PHY ID The PHY ID is one octet that uniquely identifies a specific implementation of the PHY, as specified in Annex B of ISO/IEC 26908:2009
22、. Requestors shall specify a unique string for registration with a PHY ID value. 4.2 Specifier ID The Specifier ID is a two octet value that uniquely identifies the owner of any Specifier ID as specified in Annex C of ISO/IEC 26907:2009. Requestors shall specify a unique string for registration with
23、 a Specifier ID value. 4.3 Regulatory Domain The Regulatory Domain Number is a value that uniquely identifies a specific regulatory domain, as specified in 16.8.18 of ISO/IEC 26907:2009. The Registration Authority shall specify a unique string for each Regulatory Domain Number value as required by r
24、egulatory changes. 5 Registration Authority 5.1 Appointment 2.7.2.1 of the ISO/IEC JTC 1 Directives direct appointment of the Registration Authority for the International Registers defined in Clause 4. 5.2 Duties 5.2.1 Maintenance of International Registers The Registration Authority shall maintain
25、the International Registers specified in 4.1 and 4.2 due to Registration as specified in Clause 7, withdrawal (as specified in Clause 8) or amendment (as specified in Clause 9) of assigned strings for allocated PHY ID or Specifier ID values. The Registration Authority shall maintain the Internationa
26、l Regulatory Domain (http:/www.ecma- international.org/publications/standards/UWB_Regulatory_Domain.htm) Register specified in 4.3 if and when regulations so require. 5.2.2 Publication of public content of International Registers The Registration Authority shall publish the assigned values and assoc
27、iated descriptions from the International Registers for public access at http:/www.ecma-international.org/publications/standards/Ecma- 368.htm at no cost. 5.2.3 Inform the requestor of the decision The Registration Authority shall inform the requestor of the decision to register, reject, withdraw or
28、 amend. ISO/IEC 13560:2009(E) ISO/IEC 2009 All rights reserved 36 Registration requests Using the forms at the International PHY-ID (http:/www.ecma-international.org/publications/standards/UWB_phy_id.htm) and Specifier-ID (http:/www.ecma-international.org/publications/standards/UWB_specifier_id.htm)
29、 Registers, implementers of ISO/IEC 26907 and/or ISO/IEC 26908 may request registration of a unique string for a value in the International Registers specified in 4.1 and 4.2. 7 Registration procedure The Registration Authority shall: a) Review registration requests as specified in Clause 6; b) Asce
30、rtain that registration requests are in accordance with this Standard; c) If required, indicate to the requestor the changes needed to meet the requirements of this Standard; d) Approve or reject the registration request; e) In case of approval, allocate and add the PHY ID and/or the Specifier ID va
31、lue to the International Registers with the assigned string; f) Inform the requestor of the registration or rejection within 15 business days. 8 Withdrawal procedure The requestor may declare withdrawal of its support for its entry in an International Register by using the form accessible from http:
32、/www.ecma-international.org/publications/standards/Ecma-368.htm, if so desired accompanied with the reason. Withdrawal shall not change the registered string and allocated value in the International Register; the Registration Authority shall mark the entry as withdrawn with the withdrawal date and i
33、nform the requestor accordingly. 9 Amendment procedure The requestor may request amendment of the strings in one of its entries in an International Register by using the form accessible at http:/www.ecma-international.org/publications/standards/Ecma-368.htm. Only when the RA confirms the mistake or
34、in case of name changes, the Registration Authority is permitted to correct the string in the International Registers and shall inform the requestor accordingly. The Registration Authority may periodically query the requestor to validate its assigned entry and amend or withdraw it as needed. 10 Appeal procedure The Registration Authority in cooperation with the ISO IT Task Force (ITTF) shall respond to the appeal within 20 business days after receipt of the appeal. ISO/IEC 13560:2009(E) ICS 35.110 Price based on 3 pages ISO/IEC 2009 All rights reserved
