1、 ISO 2012 Cranes Control layout and characteristics Part 1: General principles AMENDMENT 1 Appareils de levage charge suspendue Disposition et caractristiques des commandes Partie 1: Principes gnraux AMENDEMENT 1 INTERNATIONAL STANDARD ISO 7752-1 Second edition 2010-06-01 Reference number ISO 7752-1
2、:2010/Amd.1:2012(E) AMENDMENT 1 2012-12-01 ISO 7752-1:2010/Amd.1:2012(E) ii ISO 2012 All rights reserved COPYRIGHT PROTECTED DOCUMENT ISO 2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechani
3、cal, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.o
4、rg Published in Switzerland ISO 7752-1:2010/Amd.1:2012(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committe
5、es. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the Inte
6、rnational Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International S
7、tandards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the su
8、bject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Amendment 1 to ISO 7752-1:2010 was prepared by Technical Committee ISO/TC 96, Cranes, Subcommittee SC 7, Tower cranes. ISO 2012 All rights reserved iii Cranes Control layout and characteristics P
9、art 1: General principles AMENDMENT 1 Page 1, Clause 2 Add the following reference: “ISO 12480-1:1997, Cranes Safe use Part 1: General” Page 5, Clause 5 Add the following subclause: “5.2.7 The requirements for use of remote control shall be in accordance with ISO 12480-1:1997, 8.3.2.” ISO 7752-1:2010/Amd.1:2012(E) ISO 2012 All rights reserved 1ISO 7752-1:2010/Amd.1:2012(E) ISO 2012 All rights reserved ICS 53.020.01 Price based on 1 page
