1、 IEEE Standard for the ElectricalProtection of Communication Facilities Serving Electric Supply Locations through the Use of Optical Fiber Systems Sponsored by the Power System Communications Committee IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE Power and Energy Society IEEE Std 487.2-2013IE
2、EE Std 487.2-2013 IEEE Standard for the Electrical Protection of Communication Facilities Serving Electric Supply Locations through the Use of Optical Fiber Systems Sponsor Power System Communications Committee of the IEEE Power and Energy Society Approved 23 August 2013 IEEE-SA Standards Board Abst
3、ract: Safe and reliable methods for the electrical protection of telecommunication facilities serving electric supply locations through the use of optical fiber systems for the entire facility are presented in this standard. Keywords: electric power stations, electric supply locations, electrical pr
4、otection, fiber optic systems, ground potential rise, high-voltage environment, IEEE 487.2, optical fiber systems The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2013 by The Institute of Electrical and Electronics Engineers, Inc. All
5、rights reserved. Published 20 September 2013. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Cen
6、ter. Copyright 2013 IEEE. All rights reserved. iv Notice to users Laws and regulations Users of IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requiremen
7、ts. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyr
8、ights This document is copyrighted by the IEEE. It is made available for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By maki
9、ng this document available for use and adoption by public authorities and private users, the IEEE does not waive any rights in copyright to this document. Updating of IEEE documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance o
10、f new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. In order to determine wheth
11、er a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/standards.ieee.org/index.html or contact the IEEE at the address listed previously. For more information about the IEEE Standards A
12、ssociation or the IEEE standards development process, visit IEEE-SA Website at http:/standards.ieee.org/index.html. Errata Errata, if any, for this and all other standards can be accessed at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged to check this UR
13、L for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity of any patent rights
14、in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submit
15、ter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a
16、 Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions provided in conne
17、ction with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own respon
18、sibility. Further information may be obtained from the IEEE Standards Association. Copyright 2013 IEEE. All rights reserved. v Participants At the time this IEEE standard was completed, the Wire-line Working Group had the following membership: Percy E. Pool, Chair Larry S. Young, Vice Chair Steven B
19、lume Joe Boyles Timothy Conser Bhimesh Dahal Jean de Seve Ernest Duckworth John Fuller Ernest Gallo Dave Hartmann Dan Jendek Richard Knight Randall Mears Mark Tirio Thomas Vo The following members of the individual balloting committee voted on this standard. Balloters may have voted for approval, di
20、sapproval, or abstention. William Ackerman Ali Al Awazi Thomas Barnes David Bassett R. Baysden Steven Blume Gustavo Brunello William Bush William Byrd Timothy Conser Randall Dotson Ernest Duckworth Dan Evans Doaa Galal Frank Gerleve Mietek Glinkowski Jalal Gohari Randall Groves Jeffrey Helzer Lee He
21、rron Gary Heuston Werner Hoelzl C. Huntley Noriyuki Ikeuchi Gael Kennedy Yuri Khersonsky Richard Knight Jim Kulchisky Chung-Yiu Lam Michael Lauxman Lawrenc Long William McCoy Joseph Mears Jose Morales Jerry Murphy H. Nerhood Michael S. Newman Joe Nims Gary Nissen Lorraine Padden Bansi Patel Percy E.
22、 Pool Craig Preuss John Randolph Michael Roberts Charles Rogers Thomas Rozek Steven Sano Bartien Sayogo Dennis Schlender Devki Sharma Jerry Smith John Spare Gary Stoedter William Taylor David Tepen Mark Tirio Thomas Tullia Eric Udren John Vergis Jane Verner John Wang Kenneth White James Wilson Larry
23、 S. Young When the IEEE-SA Standards Board approved this standard on 23 August 2013, it had the following membership: John Kulick, Chair David J. Law, Vice Chair Richard H. Hulett, Past Chair Konstantinos Karachalios, Secretary Masayuki Ariyoshi Peter Balma Farooq Bari Ted Burse Wael William Diab St
24、ephen Dukes Jean-Philippe Faure Alexander Gelman Mark Halpin Gary Hoffman Paul Houz Jim Hughes Michael Janezic Joseph L. Koepfinger* Oleg Logvinov Ron Petersen Gary Robinson Jon Walter Rosdahl Adrian Stephens Peter Sutherland Yatin Trivedi Phil Winston Yu Yuan *Member Emeritus Copyright 2013 IEEE. A
25、ll rights reserved. vi Also included are the following nonvoting IEEE-SA Standards Board liaisons: Richard DeBlasio, DOE Representative Michael Janezic, NIST Representative Julie Alessi IEEE Standards Program Manager, Document Development Erin Spiewak IEEE Standards Program Manager, Technical Progra
26、m Development Copyright 2013 IEEE. All rights reserved. vii Introduction This introduction is not part of IEEE Std 487.2-2013, IEEE Standard for the Electrical Protection of Communication Facilities Serving Electric Supply Locations through the Use of Optical Fiber Systems. Some electrical environme
27、nts, collectively called electric supply locations, require the application of unique electrical protection techniques because of their special nature. One such environment is the electric power station or substation. Another is at, or near, power line transmission and distribution structures such a
28、s towers or poles. Such structures often provide a convenient site for the location of wireless, personal communications service, and cellular antennas and their associated electronic equipment that is served by a link to the wired telecommunications network. This standard assumes that optical fiber
29、 cables are to be used to provide electrical isolation for telecommunications services to these electric supply locations. Refer to IEEE Std 367 or IEEE Std 487 for other applications. This standard describes applications consisting entirely of optical fiber cables. For applications where both metal
30、lic cables and fiber cables are used (i.e., hybrid applications), the user is referred to IEEE Std 487.3. Some delays in site activation often occur due to the time involved in obtaining electrical information data for most high-voltage tower or pole sites. The delays may be eliminated by using the
31、optical fiber solutions described in this standard. This project is part of a reorganization of IEEE Std 487 in which the main document is broken down into a family of related documents (i.e., dot-series) segregated on the basis of technology: 487 487.1 Metallic wire-line 487.2 Optical fiber systems
32、 487.3 Hybrid facilities 487.4 Neutralizing transformers 487.5 Isolation transformers This standard has been prepared by the Wire-Line Subcommittee of the Power System Communications Committee of the IEEE Power and Energy Society. This standard represents the consensus of both power and telecommunic
33、ations engineers. This standard, along with IEEE Std 487.3, will replace, in its entirety, the existing IEEE Std 1590-2009. Copyright 2013 IEEE. All rights reserved. viii Contents 1. Overview 1 1.1 Scope . 2 1.2 Purpose 2 2. Normative references 2 3. Definitions, abbreviations, and acronyms 3 3.1 De
34、finitions . 3 3.2 Abbreviations and acronyms . 4 4. Overview of telecommunications service to electric supply locations . 5 4.1 Electric power stations . 5 4.2 Wireless cell sites 5 4.3 Service via metallic wire-line facilities . 5 4.4 Service via fiber optic facilities . 5 4.5 Service via microwave
35、 systems . 6 4.6 Wireless site owners responsibilities 6 5. Powering arrangements at electric supply locations . 6 5.1 Typical ac power service to wireless locations at power line towers or poles . 6 5.2 Distribution transformers . 6 5.3 Electrostatic coupling 8 5.4 Engine generating units . 8 6. Te
36、lecommunications service to electric supply locations . 9 6.1 Wireless sites at electric supply locations 9 6.2 Wireless sites within zone of influence (ZOI) 10 6.3 Locations at, or near, high-voltage towers or poles 10 6.4 Electrical protection considerations for telecommunications outside plant se
37、rving high-voltage tower and pole sites 11 6.5 Electrical protection measures 11 7. Telecommunications service to electric supply locationsrecommendations12 7.1 GPR-related protection considerations .12 7.2 Induction-related protection considerations 12 7.3 Benefits of all-dielectric cables.12 8. Co
38、nstruction concerns and general recommendations .13 8.1 Existing facilities 13 9. Typical dc powering arrangements at the optical electrical interface (OEI)13 10. Installation and inspection considerations .13 10.1 Installation considerations 13 10.2 Inspection considerations 14 11. Safety .14 11.1
39、General safety considerations .14 11.2 Electrical safety 14 11.3 Radio frequency (RF) safety awareness .15 Annex A (informative) Bibliography 16 Copyright 2013 IEEE. All rights reserved. ix Annex B (informative) Locating buried plant .19 B.1 Overview 19 B.2 Locating methods .19 B.3 Benefits 20 B.4 R
40、ecommendations 20 Copyright 2013 IEEE. All rights reserved. 1 IEEE Standard for the Electrical Protection of Communication Facilities Serving Electric Supply Locations through the Use of Optical Fiber Systems IMPORTANT NOTICE: IEEE Standards documents are not intended to ensure safety, health, or en
41、vironmental protection, or ensure against interference with or from other devices or networks. Implementers of IEEE Standards documents are responsible for determining and complying with all appropriate safety, security, environmental, health, and interference protection practices and all applicable
42、 laws and regulations. This IEEE document is made available for use subject to important notices and legal disclaimers. These notices and disclaimers appear in all publications containing this document and may be found under the heading “Important Notice” or “Important Notices and Disclaimers Concer
43、ning IEEE Documents.” They can also be obtained on request from IEEE or viewed at http:/standards.ieee.org/IPR/disclaimers.html. 1. Overview During a power fault that occurs externally to an electric supply location, some portion of the fault current will return to the power systems source(s) of gen
44、erating power in the network through the electric supply location grid impedance. This current return may cause a large increase in potential to be developed in and around the electric supply location i.e., ground potential rise (GPR) zone of influence (ZOI) with respect to remote earth locations. T
45、his GPR will result in current flowing into the wire-line networks or the power system neutral or any metallic infrastructures connected to the grid under study. For telecommunication facilities, this creates a transferred voltage condition as defined in 8.1.6 and 17.9 of IEEE Std 80-2000. When a fa
46、ult occurs on the power line transmission and distribution towers or poles, the current will return to the source(s) via the earth and various metallic paths available. The fault current will divide, and the resulting currents will return to their source(s) in proportion to their individual path imp
47、edances. Some power systems have a neutral return path while others do not. The absence of the neutral return path tends to produce a higher GPR. When metallic telecommunications cables and secondary neutrals are extended into electric supply locations, they represent remote earth and provide a sign
48、ificant discharge path during faults. A properly engineered and installed all-dielectric optical fiber cable will provide immunity from the effects of fault-produced GPR and induction, as well as lightning-induced phenomena, at these locations. Although the use of non-dielectric optical fiber cables
49、 is not recommended, guidance is provided for existing non-dielectric optical fiber cables. IEEE Std 487.2-2013 IEEE Standard for the Electrical Protection of Communication Facilities Serving Electric Supply Locations through the Use of Optical Fiber Systems Copyright 2013 IEEE. All rights reserved. 2 The main emphasis of this standard is the electrical protection of telecommunication facilities serving electric supply locations using optical fiber systems. The overall electrical protection scheme for the particular location shoul