1、 IEC 61169-53 Edition 1.0 2015-09 INTERNATIONAL STANDARD NORME INTERNATIONALE Radio-frequency connectors Part 53: Sectional specification for RF coaxial connectors with inner diameter of outer conductor 16 mm with screw lock Characteristic impedance 50 (Type S7-16) Connecteurs pour frquences radiole
2、ctriques Partie 53: Spcification intermdiaire relative aux connecteurs coaxiaux pour frquences radiolectriques avec diamtre intrieur des conducteurs extrieurs de 16 mm verrouillage vis Impdance caractristique 50 (Type S7-16) IEC 61169-53:2015-09(en-fr) colour inside THIS PUBLICATION IS COPYRIGHT PRO
3、TECTED Copyright 2015 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs
4、 member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee for further information. Droits de reproduc
5、tion rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de lIEC ou du Comit national de lIEC du pays du demand
6、eur. Si vous avez des questions sur le copyright de lIEC ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de lIEC de votre pays de rsidence. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22
7、 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The
8、technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. IEC Catalogue - webstore.iec.ch/catalogue The stand-alone application for consulting the entire bibliographical i
9、nformation on IEC International Standards, Technical Specifications, Technical Reports and other documents. Available for PC, Mac OS, Android Tablets and iPad. IEC publications search - www.iec.ch/searchpub The advanced search enables to find IEC publications by a variety of criteria (reference numb
10、er, text, technical committee,). It also gives information on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Stay up to date on all new IEC publications. Just Published details all new publications released. Available online and also once a month by
11、 email. Electropedia - www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 30 000 terms and definitions in English and French, with equivalent terms in 15 additional languages. Also known as the International Electrotechnical Vocabulary (
12、IEV) online. IEC Glossary - std.iec.ch/glossary More than 60 000 electrotechnical terminology entries in English and French extracted from the Terms and Definitions clause of IEC publications issued since 2002. Some entries have been collected from earlier publications of IEC TC 37, 77, 86 and CISPR
13、. IEC Customer Service Centre - webstore.iec.ch/csc If you wish to give us your feedback on this publication or need further assistance, please contact the Customer Service Centre: csciec.ch. A propos de lIEC La Commission Electrotechnique Internationale (IEC) est la premire organisation mondiale qu
14、i labore et publie des Normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications IEC Le contenu technique des publications IEC est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum
15、ou amendement peut avoir t publi. Catalogue IEC - webstore.iec.ch/catalogue Application autonome pour consulter tous les renseignements bibliographiques sur les Normes internationales, Spcifications techniques, Rapports techniques et autres documents de lIEC. Disponible pour PC, Mac OS, tablettes An
16、droid et iPad. Recherche de publications IEC - www.iec.ch/searchpub La recherche avance permet de trouver des publications IEC en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. IEC Just
17、 Published - webstore.iec.ch/justpublished Restez inform sur les nouvelles publications IEC. Just Published dtaille les nouvelles publications parues. Disponible en ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne de termes lectroniques
18、 et lectriques. Il contient plus de 30 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalents dans 15 langues additionnelles. Egalement appel Vocabulaire Electrotechnique International (IEV) en ligne. Glossaire IEC - std.iec.ch/glossary Plus de 60 000 entres terminologiqu
19、es lectrotechniques, en anglais et en franais, extraites des articles Termes et Dfinitions des publications IEC parues depuis 2002. Plus certaines entres antrieures extraites des publications des CE 37, 77, 86 et CISPR de lIEC. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des com
20、mentaires sur cette publication ou si vous avez des questions contactez-nous: csciec.ch. IEC 61169-53 Edition 1.0 2015-09 INTERNATIONAL STANDARD NORME INTERNATIONALE Radio-frequency connectors Part 53: Sectional specification for RF coaxial connectors with inner diameter of outer conductor 16 mm wit
21、h screw lock Characteristic impedance 50 (Type S7-16) Connecteurs pour frquences radiolectriques Partie 53: Spcification intermdiaire relative aux connecteurs coaxiaux pour frquences radiolectriques avec diamtre intrieur des conducteurs extrieurs de 16 mm verrouillage vis Impdance caractristique 50
22、(Type S7-16) INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE ICS 33.120.30 ISBN 978-2-8322-2878-4 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale Warning! Make sure that you obtai
23、ned this publication from an authorized distributor. Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agr. colour inside 2 IEC 61169-53:2015 IEC 2015 CONTENTS FOREWORD . 4 1 Scope 6 2 Normative references 6 3 Mating face and gauge information 6 3.1 Dimensio
24、ns General connectors Grade 2 6 3.1.1 Connector with pin-centre contact 6 3.1.2 Connector with socket centre contact 7 3.2 Gauges . 8 3.2.1 Gauge pin for socket-centre contact 8 3.2.2 Test procedure 9 3.3 Dimensions Standard test connectors Grade 0 9 3.3.1 Connector with pin-centre contact 9 3.3.2 S
25、tandard test connector with socket-centre contact . 10 4 Quality assessment procedures . 12 4.1 General . 12 4.2 Ratings and characteristics (see Clause 5 of IEC 61169-1:2013) 12 4.3 Test schedule and inspection requirements. 14 4.3.1 Acceptance tests . 14 4.3.2 Periodic tests . 14 4.4 Procedures fo
26、r the quality conformance 15 4.4.1 Quality conformance inspection . 15 4.4.2 Qualification approval and its maintenance 16 5 Instructions for preparation of detail specifications 16 5.1 General . 16 5.2 Identification of the component . 16 5.3 Performances . 16 5.4 Marking, ordering information and
27、related matters 16 5.5 Selection of tests, test conditions and severities . 16 5.6 Blank detail specification pro-forma for type S7-16 connector . 17 6 Marking . 21 6.1 Marking of component . 21 6.2 Marking and contents of package 21 Figure 1 Connector with pin-centre contact (for dimensions, see Ta
28、ble 1) 7 Figure 2 Connector with socket-centre contact (for dimensions, see Table 2). 8 Figure 3 Gauge pin for socket-centre contact (for dimensions, see Table 3) . 9 Figure 4 Connector with pin-centre contact (for dimensions, see Table 4) 10 Figure 5 Connector with socket-centre contact (for dimens
29、ions, see Table 5). 11 Table 1 Dimensions of connector with pin-centre contact . 7 Table 2 Dimensions of connector with socket centre contact 8 Table 3 Dimensions of gauge pin for socket-centre contact 9 Table 4 Dimensions of connector with pin-centre contact . 10 Table 5 Dimensions of connector wit
30、h socket-centre contact 11 IEC 61169-53:2015 IEC 2015 3 Table 6 Rating and characteristics . 12 Table 7 Acceptance tests . 14 Table 8 Periodic tests 15 4 IEC 61169-53:2015 IEC 2015 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ RADIO-FREQUENCY CONNECTORS Part 53: Sectional specification for RF coaxial
31、connectors with inner diameter of outer conductor 16 mm with screw lock Characteristic impedance 50 (Type S7-16) FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committee
32、s). The object of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available
33、Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental organiz
34、ations liaising with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical mat
35、ters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC Nation
36、al Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IE
37、C National Committees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC itsel
38、f does not provide any attestation of conformity. Independent certification bodies provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent certification bodies. 6) All users should ensure that th
39、ey have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature
40、whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced pu
41、blications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International
42、Standard IEC 61169-53 has been prepared by subcommittee 46F: RF and microwave passive components, of IEC technical committee 46: Cables, wires, waveguides, R.F. connectors, R.F. and microwave passive components and accessories. The text of this standard is based on the following documents: FDIS Repo
43、rt on voting 46F/309/CDV 46F/321/RVC Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2. IEC 61169-53:2015 IEC 2015 5 A list of all par
44、ts of the IEC 61169 series, under the general title: Radio-frequency connectors, can be found on the IEC website. The committee has decided that the contents of this publication will remain unchanged until the stability date indicated on the IEC website under “http:/webstore.iec.ch“ in the data rela
45、ted to the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. IMPORTANT The colour inside logo on the cover page of this publication indicates that it contains colours which are considered to be useful for the correct unders
46、tanding of its contents. Users should therefore print this document using a colour printer. 6 IEC 61169-53:2015 IEC 2015 RADIO-FREQUENCY CONNECTORS Part 53: Sectional specification for RF coaxial connectors with inner diameter of outer conductor 16 mm with screw lock Characteristic impedance 50 (Typ
47、e S7-16) 1 Scope This part of IEC 61169, which is a sectional specification (SS), provides information and rules for the preparation of detail specifications (DS) for RF coaxial connectors with threaded coupling, typically for use in 50 cable networks (Type S7-16). It prescribes mating face dimensio
48、ns for general purpose connectors grade 2, dimensional details of standard test connectors-grade 0, gauging information and tests selected from IEC 61169-1, applicable to all detail specifications relating to series 4.1-9.5 RF connectors. This specification indicates recommended performance characte
49、ristics to be considered when writing a detail specification and it covers test schedules and inspection requirements for assessment levels M and H. The S7-16 series RF coaxial connectors with nominal impedance 50 are threaded coupling units which are used with all kinds of RF cables and microstrips in microwave transmission system. And the working
