欢迎来到麦多课文档分享! | 帮助中心 海量文档,免费浏览,给你所需,享你所想!
麦多课文档分享
全部分类
  • 标准规范>
  • 教学课件>
  • 考试资料>
  • 办公文档>
  • 学术论文>
  • 行业资料>
  • 易语言源码>
  • ImageVerifierCode 换一换
    首页 麦多课文档分享 > 资源分类 > PDF文档下载
    分享到微信 分享到微博 分享到QQ空间

    SAE J 855-2009 Test Method of Stretch and Set of Textiles and Plastics《织物、塑料制品集和伸缩测试方法》.pdf

    • 资源ID:1027273       资源大小:57.23KB        全文页数:3页
    • 资源格式: PDF        下载积分:10000积分
    快捷下载 游客一键下载
    账号登录下载
    微信登录下载
    二维码
    微信扫一扫登录
    下载资源需要10000积分(如需开发票,请勿充值!)
    邮箱/手机:
    温馨提示:
    如需开发票,请勿充值!快捷下载时,用户名和密码都是您填写的邮箱或者手机号,方便查询和重复下载(系统自动生成)。
    如需开发票,请勿充值!如填写123,账号就是123,密码也是123。
    支付方式: 支付宝扫码支付    微信扫码支付   
    验证码:   换一换

    加入VIP,交流精品资源
     
    账号:
    密码:
    验证码:   换一换
      忘记密码?
        
    友情提示
    2、PDF文件下载后,可能会被浏览器默认打开,此种情况可以点击浏览器菜单,保存网页到桌面,就可以正常下载了。
    3、本站不支持迅雷下载,请使用电脑自带的IE浏览器,或者360浏览器、谷歌浏览器下载即可。
    4、本站资源下载后的文档和图纸-无水印,预览文档经过压缩,下载后原文更清晰。
    5、试题试卷类文档,如果标题没有明确说明有答案则都视为没有答案,请知晓。

    SAE J 855-2009 Test Method of Stretch and Set of Textiles and Plastics《织物、塑料制品集和伸缩测试方法》.pdf

    1、_ SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising there

    2、from, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. Copyright 2009 SAE International All rights reserved. No part of this publication m

    3、ay be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA)

    4、 Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org SURFACEVEHICLE STANDARD J855 NOV2009 Issued 1963-06 Revised 2009-11Superseding J855 SEP2002 Test Method of Stretch and Set of Textiles and Plastics RATIONALE Change temperature Section 4 and remove sample location re

    5、strictions in Section 4. Add bold font to Section 4, Section 5 add L1. 1. SCOPE This method of test applies to the measurement of elastic and recovery properties of materials after being subjected to a low-static load. 2. REFERENCES There are no referenced publications specified herein. 3. APPARATUS

    6、 REQUIRED 3.1 Fixtures The vice grip clamps are preferred because of the speed and ease of operation. Refer to Figure 1. 3.2 Weight A weight is attached to the clamp on the suspended end of the test specimen. The clamp and the weight together shall total 12.25 kg (27 lb) unless otherwise specified.

    7、4. TEST SPECIMENS At 23 C 2 C (70 F 3 F) and 50% 5% relative humidity, cut three test specimens 76 mm x 229 mm (3 in x 9 in) (or as specified) each the machine direction, (MD), across machine direction (AMD) and bias direction (45 degree angle, both directions were applicable). The MD stretch and se

    8、t are measured on the specimens with the long dimension parallel to the MD, and the AMD stretch and set are measured on the specimens with the long dimension parallel to the AMD. For woven fabrics such as bodycloth, sidewall, or headlining, the specimens should be cut slightly oversized and the yarn

    9、s unraveled on each side until the 76 mm (3 in) dimension is attained. SAE J855 Revised NOV2009 Page 2 of 3 FIGURE 1 - CLAMP AND FIXTURE ASSEMBLY FOR STRETCH AND SET OF TEXTILES SAE J855 Revised NOV2009 Page 3 of 3 5. PROCEDURE Mark two parallel lines (L1) 76 mm (3 in) apart (or as specified) center

    10、ed in the lengthwise direction of each specimen. Place benchmark lines in the center of each parallel line. Fasten the clamps firmly at each end of the test specimen. One clamp is attached to the supporting fixture and the weight is attached to the clamp on the other end. The weight is lowered caref

    11、ully to prevent undue stress on the specimen, and the assembly is suspended vertically for 5 min. With the weight still applied measure the length of the section between the two parallel lines at the benchmarks. The reading should be to the closest 0.40 mm (1/64 in) and record the results as L2. Rem

    12、ove the clamps and weight, and allow the specimen to recover in a horizontal position for 5 min. Again measure the length of the section between benchmarks and record as L3.16. CALCULATIONS AND REPORT Report the data as percent stretch and percent set calculated as follows in Equation 1: % StretchL2

    13、L1L1- 100% SetL3L1L1-= 100=(Eq. 1) where measured lengths are taken between parallel lines at benchmarks: L1= Original length between parallel lines at bench marks L2= Measured length after the weight is applied for 5 min L3= Measured length after the 5 min recovery period Report the average of the

    14、results for the three MD direction specimens as percentage MD stretch and set. Report the average of the results for the AMD three direction specimens as percentage AMD stretch and set. Report the average of the results for all the bias direction specimens as percentage bias stretch and set. 7. NOTE

    15、S 7.1 Marginal Indicia A change bar (I) located in the left margin is for the convenience of the user in locating areas where technical revisions, not editorial changes, have been made to the previous issue of this document. An (R) symbol to the left of the document title indicates a complete revisi

    16、on of the document, including technical revisions. Change bars and (R) are not used in original publications, nor in documents that contain editorial changes only. PREPARED BY THE SAE TEXTILES AND FLEXIBLE PLASTICS COMMITTEE 1Note in Figure 1. Peterson No. 8 clamp or equivalent clamp as agreed upon between contractual partys.


    注意事项

    本文(SAE J 855-2009 Test Method of Stretch and Set of Textiles and Plastics《织物、塑料制品集和伸缩测试方法》.pdf)为本站会员(eveningprove235)主动上传,麦多课文档分享仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对上载内容本身不做任何修改或编辑。 若此文所含内容侵犯了您的版权或隐私,请立即通知麦多课文档分享(点击联系客服),我们立即给予删除!




    关于我们 - 网站声明 - 网站地图 - 资源地图 - 友情链接 - 网站客服 - 联系我们

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1 

    收起
    展开