1、_SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising theref
2、rom, is the sole responsibility of the user.”SAE reviews each technical report at least every five years at which time it may be revised, reaffirmed, stabilized, or cancelled. SAE invites your written comments and suggestions.Copyright 2016 SAE InternationalAll rights reserved. No part of this publi
3、cation may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE.TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada)Tel: +1 724-776-4970 (out
4、side USA)Fax: 724-776-0790Email: CustomerServicesae.orgSAE WEB ADDRESS: http:/www.sae.orgSAE values your input. To provide feedbackon this Technical Report, please visithttp:/www.sae.org/technical/standards/AMS4773GAEROSPACEMATERIAL SPECIFICATIONAMS4773 REV. GIssued 1959-01Reaffirmed 2009-06Revised
5、2016-02Superseding AMS4773FSilver Alloy, Brazing Filler Metal60Ag 30Cu 10Sn1115 to 1325 F (602 to 718 C) Solidus-Liquidus RangeUNS P07600RATIONALEAMS4773G incorporates the industry standard requirements of AWS A5.8 and is a Five Year Review and update of this specification.1. SCOPE1.1 FormThis speci
6、fication covers a silver alloy in the form of wire, rod, sheet, strip, foil, pig, powder, shot, and chips and a viscous mixture (paste) of powder in a suitable binder.1.2 ApplicationThis material has been used typically for joining ferrous metals, particularly austenitic steels and alloys, requiring
7、 high joint strength up to 600 F (316 C) for short-time service or up to 400 F (204 C) for long-time service, and for joining nonferrous metals except those having a base of titanium, aluminum or magnesium, but usage is not limited to such applications. This filler metal is particularly suitable for
8、 brazing in hydrogen or inert atmosphere.2. APPLICABLE DOCUMENTSThe issue of the following documents in effect on the date of the purchase order forms a part of this specification to the extent specified herein. The supplier may work to a subsequent revision of a document unless a specific document
9、issue is specified. When the referenced document has been cancelled and no superseding document has been specified, the last published issue of that document shall apply.2.1 SAE PublicationsAvailable from SAE International, 400 Commonwealth Drive, Warrendale, PA 15096-0001, Tel: 877-606-7323 (inside USA and Canada) or +1 724-776-4970 (outside USA), www.sae.org.AMS2222 Tolerances, Copper and Copper Alloy Sheet, Strip, and PlateAMS2224 Tolerances, Copper and Copper Alloy Wire
